Melbourne Instruments ROTO-CONTROL Stands (Pair)
Melbourne Instruments ROTO-CONTROL Stands give your controller a raised, angled position for easier viewing and operation. The pair uses lightweight PETG construction, a snugger locking fit and three non-slip silicon feet per stand, while the clip-in design keeps the setup clean and leaves rear ports accessible.
Raise Your Viewing Angle
The approximately 30° angled design elevates your ROTO-CONTROL so its controls are easier to see and reach during operation. It creates a more upright position on the surface, making the controller’s layout more visible without adding a bulky support structure around it.
Secure, Lightweight Construction
Each stand is 3D printed from high-quality PETG, balancing strength with a lightweight build. The material also allows mild flexibility when the stand is snapped onto your ROTO-CONTROL, while the improved design provides a snugger ‘locking’ fit for a secure, close-fitting setup.
Stay Steady While You Work
Three non-slip silicon feet per stand help prevent slipping and sliding during operation. Together with the angled form, they keep your device sitting flat and steady on most surfaces, so the stand stays in place while you adjust and operate the controller.
Clean Access Around the Rear
The innovative clip-in design removes the need for a middle reinforcement bar, keeping the look clean and unobstructed. It also leaves full access to all rear ports, making it easier to connect cables and keep the area behind your ROTO-CONTROL organised.
Key Features
- Raises the ROTO-CONTROL for improved visibility and operation
- Provides a snugger ‘locking’ fit with the improved design
- Combines lightweight PETG construction with mild flexibility
- Uses three non-slip silicon feet per stand for steady placement
- Keeps rear ports accessible for cable management




